pm.mymon.name

velmi dobre to vyzera veru.co bude nasledovat?GRAULUJEM

Hodně dobrý a palec nahoru za vlastní úpravy, o tom se mi může jen zdát.

velmi dobre to vyzera veru.co bude nasledovat?GRAULUJEM

momentalne zhanam nejake podklady na fordson trackson ale to je na dlhe lakte...
brzdic - mne sa moze zdat o tvojom patinovany, este teraz sa mi sniva tvoj Sherman
ico - aj vonku skusim volaco pofotit.

hi Matus.
I have a question again. where these details in a pattern?


I glued parts, the thickness of the rink turned 2.8 mm, and the cut-out section gusnitsy 2 mm. and the distance between the guide tracks of 2.5 mm.


P.S.
nothing that I wrote in this thread?

Hi Maxim,
1.
circled detail are not part of my conversion...haven't paid attention to them...

2.
circled parts are there only to make it stronger... i guess you need not to use them if you impregnate rest with super glue (those days I never used to use superglue as paper glue alternative...silly boy)

3.
in this one I am putting my hands up, because I have no legitimate excuse why I didn't see it...my tracks do not even fit directly onto teeth. it just sits on it... that was my first conversion and i had no proper skills...so it just looks good with plenty mistakes...so feel free to correct my mistakes.

ale no a ty už čo stváraš parádne to je

ale no a ty už čo stváraš parádne to je

ale sak to je stary model...2013 rok, davna historia...akurat ho Maxim lepi a ma doplnujuce otazky...proste som bol este mlady a neskuseny modelar. ale polepsim sa.

vtedy som to až tak nesledoval ale neva stáva sa

in the photo looks perfect! thought that I made a mistake somewhere. or not all printed.
Yes, I have already removed one ring:


and slightly simplified assembly tracks (top - yours down - my)

Very good. it looks ok. It feels nice to see that my work is done by somebody else as well.